I am now proud to offer AR10 barrels, complete with the extension installed, headspaced and ready for you to install on your upper. I will chamber in any of the common cartridges known to work through the AR-10 or DPMS 308 action:

• 22-250 Remington
• 243 Winchester
• 260 Remington
• 7-08 Remington
• 308 Winchester
• 338x7BR
• 338 Federal
• 358 Winchester

Barrels are available in any length from 12" to about 26" and can be ordered in any profile that you want. I can drill the gas port at carbine, mid-length, rifle length or extended length positions as appropriate. There is also the option of using full length handguards to hide a shorter length gas port setup.

AR10 Barrel Pricing
Standard grade chromoly barrel	350
Shilen Match Grade chromoly barrel	425
Douglas "XX" Stainless Steel Match Grade barrel	475
Krieger Stainless Steel Supermatch Grade single point cut & hand lapped barrel	575

 

If you are re-barreling your current upper and you will be using your old bolt, I ask that you ship me that bolt for final headspacing. If you are building a new upper, be sure to buy a new bolt. I recommend against sharing a bolt between 2 uppers as it wears out the bolt and both barrel extensions.

If you request it at the time that you order your barrel, I can cut a chamber gauge for you with the same reamer. With a pair of dial calipers, you can use the gauge to properly adjust your sizing and seating dies. This will be a 2" long steel gauge with the same body, shoulder, neck and throat. You will find this gauge a life saver when working up loads to get the bullet as close to the lands as possible. This gauge will also serve as a standard to measure throat erosion against in the future, allowing you to keep track of the throat erosion on your barrel. I charge $25 for the custom chamber gauge to match your barrel.